Front beam rebuild

I left ours. If they feel and look ok then should be fine.


Sent from my iPhone using Tapatalk

 

Might be worth adding a servo bracket while it's out.

 

^this

 

Is this not a servo bracket on the last picture of the cleaned beam?

 

He’s right

 

It was on my bus before...
I had a bit more info than you all!

 

I think the chances of me getting round to fitting a servo are .......non existent!

 

I didn’t bother fitting one to ours. The braking is all part of the charm (aka I couldn’t be bothered as I have a billion other bits to do on the damn thing!)


Sent from my iPhone using Tapatalk

 

So can you retrofit a servo to a non servo bus with just the adding of the servo/bracket/vac take off then?

 

Think you need to change the master cylinder, or at least the rod that goes into it. Not sure.


Sent from my iPhone using Tapatalk

 

Just replaced my rears with boge, will keep an eye on them for leaks.

 

Mine have been fine.

 

Finally got round to calling vwheritage about my leaking shocks,( they've been on 2 years and covered about 6000 miles, ) and they're not interested, i pointed out they should be lasting for slightly longer than that, but was told "yeah well it's just the state of the roads ", well actually I don't drive over potholes because I look where I'm going. He did offer me a couple of pound off a new pair though , well how generous.

 

welcome to the world of we have had your money now ***** off

 

Yes, but Jez, you have worn them out by keep putting your bus up and down on Jenga blocks

 

yeah on the miles he's done I'm surprised anything has worn out

 

True.
Shame, as I need to order a fair bit of stuff this week so I'll spend my money elsewhere

 

And anyone else who has them, is £200 about standard for a pair of konis? Is about the best I can find but don't know if I'm missing somewhere....
Bit dear for me really.

 

Cheapest I found was larkspeed. £378 for the full set.


Sent from my iPhone using Tapatalk