sorry its camper related thread ( these seem to be getting fewer recently) There was talk that a rubber /Viton replacement for the cork valve cover would be available a while ago . Did this happen or do I have to make my own ?
I’ve been using silicone rocker cover gaskets from C&C for the last few months; they’re good quality and fit perfectly. https://www.customandcommercial.com...one_rocker_cover_gaskets_1700cc-2000cc_36575/
Can you laser cut silicone /rubber ? I don`t think you can !!! it would be either water jet cut or punched /moulded
Interested in this also. Want a fit and forget gasket that doesn't deform istanatly and slip off the head mating surface. Ones ive had over the last few year have been okay bordering on a bit poor and require patience to get em on right. once done they are fine but only confident with them for a single use only. And by that I means - once fitted they tend to not sela properly if you have the covers off again.
Ive only seen it micro water jet cut ......(I must talk work in to buying one ) .......the C&C ones must be moulded other wise the waste is huge
I had the same problem with even Elring and Victor Reinz cork gaskets and found them single use only. I have alloy rocker covers which makes it worse but the silicone gaskets are a nice fit, no leaks and the covers can be removed and refitted.
If we can get the material I can make a mould and make some gaskets, I couldn’t see the cost at C&C but could be potentially be cheaper
£19.99 for a pair, less our 10% discount. https://www.customandcommercial.com...one_rocker_cover_gaskets_1700cc-2000cc_36575/
Don`t forget the 6 quid post ......I sent a drawing away for a quote today to gauge an idea on price ,water jetted ...I don`t think they will be much cheaper but looking at the picture from C&C they buy theirs from the U/S and they don`t look machine cut ??? What was the quality like ? I presume they were 1/8" thick so i asked for a quote of 3 and 4mm standard silicon is up to 200 degrees C and will withstand occasional 250 deg
They’re manufactured in Germany and are moulded. Good quality – I wouldn’t have fitted them if they weren’t. I didn’t measure them but circa 4mm thick, more than 1/8” anyway. No problem with temperature, the combustion chamber temp will be more than 200c but the heads are cooler out at the rockers.
I have a quote . 10 off white silicone rubber water jet cut 4mm thick +/- 0.3 @ £6.60 each delivered to me ....... add a couple off quid to post out £15.20 a pair I need 2 sets so would need 3 other people to take a bit of a chance as to just buy one pair with the delivery is not viable ..... @The Little Camper Company can you do them cheaper/better than that inc. a mould etc.