1600 tinware. ONE PIECE!!! garrr...

i need one piece of tinware... its this bit..



has anyone got one laying around? not bothered about condition.

let me know.

 

nobody?

 

Possibly got a spare kicking round somewhere!!

 

If Paul doesn't have one I'll have a look. My partners dad has two engines in his workshop.

 

if either of you have.. i will be ever so grateful.
been looking all over t'internet for the bloody thing. cant find it anywhere!!

let me know
Cheers!

 

Just taken an engine out I his split today with full tin so will check tomoro fella.

 

Hi fella, had a look today and there is a piece of tin, which resembles that! The bad news is that the PO has made it themselves by using a piece of sheet and put a bend in it!!!

 

Thought I had one spare still but someone must already have it off me, sorry!

You can buy these new still, albeit quite pricey.

O.G. http://www.vwheritage.com/vw_spares_Tinware-RHS-Rear-Flat-for-1200-and-34HP-from-7336420-111119352G_act_shop.product_pID_174918_lang_EN_country_GB.htm

Brazil: http://www.vwheritage.com/vw_spares_Tinware-pushrod-thermostat-043119352ALT_act_shop.product_pID_171985_lang_EN_country_GB.htm?crumbStartPage=3&crumbStartRow=31

Repro: http://www.vwheritage.com/vw_spares_Lower-Tinware-kit-black-3pce-043119350KIT_act_shop.product_pID_101966_lang_EN_country_GB.htm?crumbStartPage=4&crumbStartRow=46

HTH

 

Oh and Deimo's aircooled is slightly cheaper repro that looks better IMO http://www.deimosaircooled.com/products/engine/cooling/lower-tinware/111-198-901

 

For £30 mate, I'd get new!

 

Found one on ebay for £13 delivered, got that. Its original and im having it all powdercoated anyway. Sorted!

 

Sorry to drag up an old thread but I got that3 piece tin set and only needed the single largest piece as the other bits are alreday there, but what is it supposed to bolt too? At the top there's nothing in place for me to run a screw through? I know the sides hold onto the heat exchangers but confused about the top

 

Screws to / through the cylinder head shrouds

 

Hmmm
Is this somethin I could be missing? When I look I can see 4 rusty tubes and no hold above them to hold this piece of tin

Sorry I'm new too this

 

12345 post a picture of what you got, and we tell you want you're missing

 

Just taken this tried to include everything relevant!!

Additionally I have this piece of tinware I was told was missing

 

Shameless bump as I'm stuck for ideas but would like to get sorted in morning

 

The picture doesn't really show it, the bit of tin at the back of the engine with the outlet on the screw holes are on the other side right next to the cylinder head, take a picture from inside the engine bay, down the back of the head behind the inlet manifold

 

Oh ok thanks, I'll have to do it tomrrrow now but u might have just given me the clues I need to work it out - thanks