Hi I have some Beatle heater exchanges on the van and the flap controls for the bug ones are on the opposite side to the van ones. Is there anyway to swap the arms over or any other way to get the. Working on the van? With out putting van ones back on? Cheers
I don't do anything. I just fit the cable directly onto the activating arm...just throw the tiny circlips away on the fitting kit and use a small bolt and a nyloc.
I think the genuine ones only have the one arm http://i106.photobucket.com/albums/m263/phade1971/IMG_0001-2.jpg
If you've got Beetley ones, strip the lower linkage off and fix a short length of flat metal sheet with a hole in it to the upper actuator arm to extend it, so the lever can be pulled bus-style.
This is great, I replaced one of my exchangers before I put my engine back in, got it all fitted, pipes connected, went to connect the cable and realised it only has one arm, the beetle one, on the wrong side! I'll have a look now at bending it over, but I don't now how the cable will cross over, I'll see!
hi guys. I have on my bus heat exchanger from a bug and had the same problem. I solve the problem quickly See photos (sorry for the quality) the cables are new and everything is going nice and smootly