Basically, where it meets the angled cuts from the engine bay. I need to be able to drill the spot welds so I can join it to this.
Brand new correct outers are available from coolair, made by autocraft engineering... fitting is absolutely spot on Only around £25 too Personally I'd make the inner... cost wise it's cheaper than anything you can buy!!
I've just found a brand new outer in the garage in unfinished shiny metal, maybe it's a cool air one or a JK one. Must have come with the bus. Is the inner just a straight piece with 2 folds then?
Not quite dude... Have a look at paras bus resto... I've got a few pictures of the inner on around page 76
The inner would be tricky to make. I thought the pattern panel was actually pretty good quality although expensive. I bought mine from coolair but it looked like a jk panel. Autocraft outer for me too, excellent fit