heater controls

Discussion in 'Mech Tech' started by kenregency, Oct 20, 2013.

  1. kenregency

    kenregency Guest

    does any one have a diagram please for cables and controls:thumbsup:
     
  2. Poptop2

    Poptop2 Administrator

    Nice one Ken I am bout to do mine.

    If Ken doesn't mind I would like to see some too, I am a bit confused as to where the totem cable goes, I have three control 2 reds 1 blue, I know the blue is cold air and has it's own operation, and I know the left and right hx cables go on corresponding red controls, but where does the totem cable attach?
     
  3. Poptop2

    Poptop2 Administrator

  4. Here you go...

    [​IMG]
     
    Poptop2 likes this.
  5. Silver

    Silver Needs points/will pay!

    Both heat pod cables go on the same red lever and the other red lever does the totem.
     
    Poptop2 likes this.
  6. Zed

    Zed Gradually getting grumpier

    That's interesting, I didn't know the walkthrough and totem were on the same lever.
     
  7. Silver

    Silver Needs points/will pay!

    Be nice to have a walkthrough vent!
     
  8. Zed

    Zed Gradually getting grumpier

    Unless you have an early which has 2x seperate blues, each HX on own cable, a lever on the totem and a knob under the seat for the walkthrough.
    I've never seen a working walkthrough/totem lever (not that I check them all).
     
  9. They are indeed (on late lates), and the walkthrough works quite well :)
     
  10. kenregency

    kenregency Guest

  11. kenregency

    kenregency Guest

  12. Poptop2

    Poptop2 Administrator

    I have an xover set up on mine. I have disconnected the walkthrough as the diverter tube was rotted through and now awaits a replacement so that bit is out of the equation for now!
     
    Pouch likes this.
  13. kenregency

    kenregency Guest

    took it back to lockup now but just rang zedd and he told me what to do but always the way when the vans put away.and come in doors i find out .:)
     
  14. Zed

    Zed Gradually getting grumpier

    When all said and done, you can do what you like with them, I've put both my hx's on one lever, disconnected the cold completely and removed the blue levers. The other red lever operates a flap on my oil cooler.
     
    Poptop2 likes this.
  15. Poptop2

    Poptop2 Administrator

    I agree now cheers silver.
     
  16. Poptop2

    Poptop2 Administrator

    Be nice to have them working as they should be though zed!
     
  17. Zed

    Zed Gradually getting grumpier

    They were on mine, and still switch the hot on and off + my totem one being a simple lever still works. :)
    I can open the window if it gets hot.
    And control my oil cooler in a way I think suits the quirky van.
     

Share This Page