Ive tried to ignore this 4 a while but> on measuring from the (level)ground to wheel arch my bus is 20mm lower on o/s>now all the necc. fittings/fitout i.e. cabinets ,including cooker ,13.5 gas bottle are down that side, and everything else i usually carry with me i.e. tools and stuff is out of bus, question is >>should i be dealing with this or is it acceptable ? ta for opinions/advice
you'll need to do an inner/outer torsion bar rotation on the splines to level it up... I did this for a customer recently... was around 20-30mm different side to side
yeah tyres fine , as regards inner/outer torsion bar rotation , one side only? (i"m assuming) any special tools required and is it a one guy fix or will i require a friend to assist? ta for advice
Spline to Height Drop Inner Spline/Outer Spline/ CM Adj / INCHES +1 -1 0.52 0.2 +2 -2 1.04 0.4 +3 -3 1.56 0.6 +4 -4 2.08 0.8 +5 -5 2.60 1.0 +6 -6 3.12 1.2 +7 -7 3.64 1.4 +8 -8 4.16 1.6 +9 -9 4.68 1.8 +10 -10 5.20 2.0 0 +1 5.81 2.3 +1 0 6.33 2.5 +2 -1 6.85 2.7 +3 -2 7.37 2.9 +4 -3 7.89 3.1 +5 -4 8.41 3.3 +6 -5 8.93 3.5 +7 -6 9.45 3.7 +8 -7 9.97 3.9 +9 -8 10.49 4.2 +10 -9 11.01 4.3 11 -10 11.53 4.5 0 +2 11.62 4.6 +2 0 12.66 5.0
