late bay shell and bits and bobs: now cut up photos added

Will you consider selling the poptop canvas on its own now fella?

 

yes interestedn in both sides, do you have a price in mind and would it be possible to come and see them? cheers

 

Sorry mate I want to sell the roof complete if I can

 

Yes mate pop over Saturday if you want. Come have a look see what you think, cuts are £25 to £75
De72 3ew ash

 

Late bay stock beam needs small repair £50
Steering wheel / stalk /column £25
Brake levers , hand brake, washer mech etc £5 / £10

 

great be with you about 10.30am. cheers

 

Hi bud

I'm after the panel under the fuel tank (right down to the floor including tank straps etc) & an engine lid. Cheers

 

Engine lid and straps are spoken for. If the panel is good under the tank is good ill put your name on it (to be totally honest I didn't know there was a panel under the tank)

 

Perfect cheers bud, just pm me.

 

super solid fuel tank. No rust £75


rust free fuel pipe £20

full and complete Rust free RHD dash, no cracks in the material. Clocks some switches £75



floor cut £25

 

panel £40


under RHD sliding door cut £40



breaking vvv

 

bump

 

Hi Ash.
How much for the seat runners both sides.
Just left a message on your mobile
Thanks

 

Sorry skippy they have already gone

 

No probs
Thanks

 

metal part of the roof left. Really good gutters, may cut if enough interest.


glass. Rear hatch, rear side, middle and quarter opener ..... i think

 

Can you cut off the brace between the jacking points on the floor cut. I'd rather have OG metal than Klockerkolm stuff that doesn't fit!
Any of the other 2 brace pieces available from under the floor that the pipes go through?

I'm also after the y piece heater junction and where it goes through the rear floor. Also if the upper rear load area has been cut, I'd like a small section of it for a repair piece as its a different profile to the cargo floor.

Also rear valance inner and outer?

 

exuptoy, i can probably help you out with the load area metal. How much do you need?

Carl

Sorry to threadjack ash lol but i know you aint got any left..

 

If you do end up chopping the roof ash give me a shout. I could do with a section.

Carl

 

You are a life saver dude. I only need a piece 4 troughs wide and the same length. Someone has started chain drilling above the tank then ran out of talent so just riveted plain plate over it!

Let me know what you want for it.

Cheers
Lyn