Took out the passenger seat which was directly bolted to floor ( they were after market ) Well I've sourced some genuine late ones to put back in but there's nothing on the ones I've got and nothing in the van to connect them to Any one got any pics of theirs for me to have a look
Welded/bolted hooks hold the base of the detachable passenger seat. There's a metal loop on the bulkhead at the back that holds the passenger backrest. Haven't got any pics, I'm afraid.
This is what was bolted to floor and to the after market seats I took out I still have to take the drivers set out yet but that looks like they have welded something to them I'll take pics when I finally get em out
These are what you need to fit that seat correctly as per the VW factory aka God intended http://pages.ebay.com/link/?nav=item.view&alt=web&id=371273600423
Mine is 1977 so would they still fit And how does the seat fit? Do they just sort of clip in and do they go down the sides or front and back
the year doesn't matter, buy the brackets in the ebay link, thay are what you need for that seat in the picture, you need 2 , they go towards the rear of the seat
Cheers I googled brackets and got some images up so I know where they go approximately towards the back I could bolt these on as I haven't got a welder Any measurements from the bulkhead for the brackets
you should find on the inner tub, the side the seatbelt stalk bolts to the 2 holes for the bracket to bolt to, I've never seen a bus without them on the inner, the outer( near the door) is usually welded but can be bolted. you can transfer the measurement over from the ones in your van