Got my self a nice new sewing machine for my door cards and seat covers and some sound deadning pads and some heat resistant spray glue for sticking the heat insulation in the inside of the van
No prob. Happy to help. Mine are a nasa employee's full set of long service badges from someone in the admin dept. three are gold one gf. One silver one bronze. The tie pin is solid gold too.
Almost after a few drinks.. http://www.ebay.co.uk/itm/VW-T2-Bay...me-/201523527860?_trksid=p2141725.m3641.l6368
It wasnt off ebay but a local classified site, It came with an old seabee outboard, oars, pump and original booklet etc £35 Similar to this http://www.ebay.co.uk/itm/Avon-Redcrest-inflatable-dinghy-/121660688959?nma=true&si=3BMUe%2B7GvxdTEJ9eJyseEJwEHQI%3D&orig_cvip=true&rt=nc&_trksid=p2047675.l2557 but minus the ply boards but plus the little engine. Bargain If anyone has one I would like the size of the ply boards. I have tried google!!!
Good little buy that mick , ive never had an avon but had a few others honwave etc. If you let it right down flat then measure a template under the tubes ie size of whole of bottom inside, then cut a piece of marine ply to that size cut into three pieces ,rub down all corners , then fit front piece first then rear piece ,then lastly middle piece (may need to bend up ends then push middle board down , then pump up slowly till firm n floor is taught.Good idea to put a couple of finger or hand holes on edges so you can take out easier, also so you can see if you start taking water threw bottom , not that it will sink even if filled with water as long as tubes are ok . I assume you have bought this to tow behind your gin palace huh