The All New, New "What have you done to your Bay today" thread.

Discussion in 'General Discussion' started by top banana racing, Aug 27, 2015.

  1. MrDavo

    MrDavo Supporter

    When you open the door of the vertical cupboard, in the back right hand corner, the bed cushion underneath fights against the hinges when the door is open, and pulls the screws out of them.

    I went to Screwfix and bought some magnetic latches, today with a ruler, pencil and a bit of dead reckoning i now have a pull off hatch. I had to ring the wife, who’s away dog sitting, and ask her where I’d find a rubber (to get my pencil lines off, she’s a teacher and has these things), she didn’t sound surprised and suggested the chemist before I explained why I wanted one, then she told me which box in which drawer to look in.
     
    Last edited: Nov 26, 2022
    Purple, Gingerbus, scrooge95 and 3 others like this.
  2. Did some knitting, so my interior light in the headbanger comes on when the tailgate is open...

    a newy4 int light 1 6s.jpg

    a newy4 int light 2 6s.jpg

    Dodged the rain and did a final skim of the lumpy bits (which I started back in September :rolleyes:)..

    a newy4 rear end 6s.jpg
     
    PanZer, nicktuft, Gingerbus and 6 others like this.
  3. Chrisd

    Chrisd Supporter

    Is that a white board on the ceiling for night time doodling?
     
    PanZer and Huyrob like this.
  4. I believe it is for serving one's haute cuisine upon.











    Aka quiche!
     
    Meltman, snotty and Chrisd like this.
  5. Yes!
     
    Chrisd likes this.
  6. Chrisd

    Chrisd Supporter

    Our cat decided he just had to sit on me, irrespective that I was reading Bentley in preparation of taking off my steading wheel. Oblivious to my book and drink, pussy cat had his way, unfortunately, Bentley and my drink became much more acquainted than I would have liked :mad:
     
  7. Chrisd

    Chrisd Supporter

    A rather large mouse or maybe a ham fisted PO had left me with a rather chewed up steering cowl and starter electrical connector. On my way to sorting this out but currently on pause whilst eBay delivers locking spade connectors as I only have the normal type :(
    IMG_20221128_113818498.jpg IMG_20221128_130718011.jpg IMG_20221128_114851356.jpg IMG_20221128_140759898.jpg


    Whilst I wait, I'm going to look at why my wipers only run fast, don't self park and won't wishie washie :)
     
  8. The crimps with the locking tabs will click in there nicely. But...does look like that red wire has overheated. Best to find out why.

    Wipers - just change the whole lot out with a new motor :thumbsup:
     
    Lasty, rob.e and Chrisd like this.
  9. JamesLey

    JamesLey Sponsor

    I know a man that flogs some fancy new motor. ;)
     
    Betty the Bay, scrooge95 and Chrisd like this.
  10. Really? Anyone we know?
     
    Meltman likes this.
  11. Looking at your cowl, looks like someone's tried to prise it off without undoing the screws underneath.
     
  12. Dismantled dashboard and started the masking for a repaint.

    Carpets, kick panels and door cards to do, but not just yet.

    7BB042F5-7BDE-4195-8BC2-8D938CEB7569.jpeg
     
    PanZer and theBusmonkey like this.
  13. Best to take the dash out, IMO. Easy enough :thumbsup:
     
    DubCat likes this.
  14. How many PICT carbs does a man actually need? Four of them, at last count.

    a newy4 carbs 6s.jpg
     
    Lasty likes this.
  15. Chrisd

    Chrisd Supporter

    Yes, that is what it looks like. Old cowl no longer has one of the screws etc. Took me quite a long time to find the cowl in a swap meet and just a year for me to get round to fitting it!

    As for my wishie washie wipers, will look at the switch first before diving into the motor side of things. Ta
     
  16. Could be the switch, but more likely to be the 40-year-old motor, I'd think.
     
    Chrisd likes this.
  17. Thanks, advice taken.

    I’ve got the wiper motor to replace and some spotlights to wire up so decided it would be easier. Plus a bunch of old wiring for a stereo that no longer exists to come out.

    Apart from a rust spot on the dash I knew about its looking pretty good.

    Any other suggestions for jobs whilst it’s apart?

    T


    90407E13-7CEE-4CBB-BB41-2237BDA6C4D3.jpeg
     
    snotty likes this.
  18. Might want to check the state of your washer hoses? Everything much easier with the whole dash out!
     
    tburton100 likes this.
  19. Chrisd

    Chrisd Supporter

    Whilst I do a few jobs round my steering column and wait for parts, I noticed that a wire on my control switch looks like it's routed incorrectly. it's not broke but, would anybody know if the green and black wire should be routed through the small hole rather than the way it currently is routed round the outside and obviously being squashed as is. Assuming it should be going down the hole, how easy is it to take the switch apart.... not that I really want to do this. Thanks.
     

    Attached Files:

  20. Zed

    Zed Gradually getting grumpier

    Certainly looks like it.
     
    Chrisd likes this.

Share This Page